Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Valve Spring Seat Question
User Name
Password
lost password?   |   register now

Thread: Valve Spring Seat Question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-08-2005 12:09 PM
Garbonzo Bojangles Well I took them to a local speedshop this morning and they didn't have any shims or retainers that would fit right. I ended up having the seats machined to fit the spring while I waited. So much for my resolve not to do that lol.
01-08-2005 11:15 AM
NorthStar From looking at your picture I would run some kind of locator even if that means machining the spring seat again so it will fit properly.
If you dont keep spring from moving around the inner spring is going to start chewing up the teflon seal.
Check out Crowers online catalog they have a pretty good selection of cutters and spring seats.

http://www.crower.com/misc/m_cat.shtml
01-08-2005 09:56 AM
machine shop tom You can fill in the area with the proper size hardened spring shim.

tom
01-07-2005 07:35 PM
Garbonzo Bojangles
Valve Spring Seat Question

I'm trying to install 1.44" springs on my Sprotsman II chevy heads. The spring seats are cut out for up to 1.55", but there is a lip around the outer edge that is probably 1.4" in diameter, which also raises the floor around .060". This lip doesn't allow the spring to sit on solid metal at all points, and therefore it can sit a little cooked. I'm worried that this will put unwanted stress on the valve guide. Should I try to get some spring locators or shims or just just install the springs as is? I am NOT going to get this machined though.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:10 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.