Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> rusted out
User Name
Password
lost password?   |   register now

Thread: rusted out Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-13-2003 07:19 PM
Gearhead forever Definatley weld them. The replacement panels will save time and money. (unless you have a buddy in a sheetmetal dept.) You can even rent 110 volt flux core mig welders. Mig with sheilding gas it the best bet. Be sure to remove as much rust as possible.(make welding 10x easier) Remember not to weld everything up at one time. lots of little tacks and stitch welds to keep distortion down. Hope this helps. Love those C-10 trucks. wish I had one.
01-11-2003 06:12 PM
collins motors co. I agree buy replacement floor panels and weld them in.On older chev trucks the rocker panels where they meet the floor is rusted also.
01-11-2003 03:07 PM
Halloweenking The only safe way I will recomend is welding in patch panels. If you check the Knowledge base in the exsterior body section there is a how to on doing this. Welding in patch panels is the only way to go on floors.

HK
01-11-2003 03:03 PM
c10_65_chevy
rusted out

I have a 65 chevy truck. and the floors are rusted in the corners and along the door. i cut off all the loose ***** off. what is the best way to patch these holes??
weld it?
fiber glass?
or any other ideas??

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:37 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.