Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> Wiring in an electric fan
User Name
lost password?   |   register now

Thread: Wiring in an electric fan Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-17-2005 11:01 PM
horvath Check THIS out.

And THIS too!

54 Chevy Pickup
03-17-2005 07:19 PM

Doc here,

Electric Fans are high current devices, You should Always use a relay when installing one to keep from frying a harness.

If you just want it in "Run" all the time the best way to do it is get a relay that will handle the draw of the fan , whatever that might be, I think usual is 30 amps.

Locate and wire the Coil for the relay, one wire to a hard ground, and the other to about a 2 amp fuse, then to any source that is hot when the key is on. This is your control circuit.

Locate the Normally open Contact and the Center wiper of the relay, wire the center wiper to the Fan motor, and the normally open side to a properly rated fuse for the motor, then to any Battery source, or the harness side of the fusible link.

That's it. You will have a fan that runs when the key is "On" at all times.

Are you sure you don't want to temp control it?

In some cases running a fan continually, can cause over-cooling which is as bad for the engine as under-cooling...

You can add a manual switch by either adding a switch between the relay fuse and the switched 12 volt source to manually control the temps. Or between ground and the ground side of the relay coil...But this too has pitfalls, If you forget to turn it back can overheat.

Hope it helps!

03-17-2005 06:12 PM
Wiring in an electric fan

I'm trying to install an electric fan out of a different pickup into my truck. Specifics really don't matter about which cars etc. I'm just trying to figure out how to add an electric fan to a vehicle without one stock. Can anyone here help me out?

I don't need it to activate at a certain temperature, just needs to turn on when the vehicle is on. I don't know if I need relays, or if I can just hook her up directly to the fuse box, etc...

Thanks for any help.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 10:23 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.