Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> PPG k36 surface primer question
User Name
Password
lost password?   |   register now

Thread: PPG k36 surface primer question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-20-2005 07:54 AM
302 Z28 I agree with the above comments about the epoxy sealer. K36 can be used as a sealer with a different activator.

Vince
03-19-2005 09:53 PM
Rick WI Final with 600 and leave it alone. When the weather warms clean with wax and grease remover, rescuff and then apply the sealer. I don't think the sealer is needed anyway. A smooth even 600 sanded surface of k36 is fine to put your base over.
03-19-2005 08:30 PM
Z-Money Pit
PPG k36 surface primer question

Hello everyone,

I am on my final coat of K36 surface primer and was wondering what grit sandpaper I should use for the final pass before the application of the epoxy sealer that I will be using (the base/clear will have to wait for the warmer weather so I am going to coat it with dp76 for now). I am aware that I will need to sand the epoxy sealer before I move on to the base color. But for now, what should I finish the K36 with.

Thanks again.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:42 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.