Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> need HEI measurement on SBC
User Name
Password
lost password?   |   register now

Thread: need HEI measurement on SBC Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-07-2003 07:13 PM
stea Thanks guys. I think if i position the motor 2 1/2 inches back from where the original firewall was i should have enough room.
04-07-2003 02:57 PM
PrimeMover Installed height, complete with Accel coil is eight and a half inches. That's measuring from the intake manifold next to where the distributor drops through, to the top of the coil. If you do not run a Crossfire cap, you'll have to allow room for a plug wire or two to pass behind the cap.

Happy fabricating!
04-07-2003 02:38 PM
bigwildgrin about 1/2 of an inch, not measuring where the wire harness plugs in or the vacuum advance.
04-07-2003 08:18 AM
stea
need HEI measurement on SBC

Trying to locate the motor mounts for my sbc on my 39 chev truck frame. Approximately how far does an HEI hang over the back of the block? Not much room to work with and my cab is off the frame. Planning on a 4" recessed firewall but need to fab the mounts now. THANKS

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.