Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> guide plates
User Name
Password
lost password?   |   register now

Thread: guide plates Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-10-2003 03:46 AM
engineczar It depends in some part to what cylinder head you're using and what size/shape the pushrod hole is. Most, if not all early cast iron heads used these holes as pushrod guides. They fit they pushrods with a small amount of side clearance and kept the pushrod/rocker assembly in line. Later heads used a rocker arm that was self aligning so the pushrod hole was opened up. The problem with the early heads is that the pushrod hole will only allow a limted amount of lift and only a 1.5 ratio rocker arm before the pushrod runs out of room in the other direction. Most people who use the early heads for racing open these holes up and use guide plates along with screw in studs. Look at the pushrod holes. If you go to roller rockers and the pushrod holes are round and/or opened way up then you need guideplates. If the holes haven't been touched then make sure the pushrod doesn't bind at any point during the rotation of the engine.
04-09-2003 04:20 PM
reddwarf This is actually a pretty good question. I have wondered this myself.

Stamped rockers don't need them and roller rockers have the same push rod "divot" as the stockers......

Is it really necessary for stock heads and 1.5 ratio rockers?
04-09-2003 04:15 PM
4 Jaw Chuck Keeps the rocker aligned on the valve stem.
04-09-2003 04:04 PM
layinitdown
guide plates

i would really appreciate if someone could explain why i have to get guide plates when i switch to my new roller rockers. i mean like what purpose do they serve?
thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:16 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.