|04-20-2005 02:14 PM|
|04-20-2005 01:03 PM|
|04-18-2005 11:16 AM|
According to my handy dandy Square D motor calculator the below are the specifics for a 5hp single phase 230v motor.
Full load current 28 amps
Minimum copper wire size #8 awg
Thermal magnetic breaker 60 amp
#8 wire is good for 50 amps
#6 wire is good for 65 amps
#4 wire is good for 85 amps
Normally wire is sized at 125% of max load. 28 X 125% = 35 amps.
Wire it properly, you will sleep better.
|04-18-2005 10:39 AM|
I've found two models that are just like the one I'm looking for at local shops around town. One at a body shop and one at a service center. One concern I've found is the pressure switch contacts. This unit uses a cheap one made in china. The contacts are thin and I don't think they will last very long. I also found out the tank is made by Douglas which is based in California. Reading there site, they seem to have a high standard in quality. That was another concern. Also, the wiring for this compressor is way over kill. The company that makes this compressor say you have to use #8 wire for zero ft up to 50 ft. If you go past 50 ft, you have to go to the next size which is #6 wire. Don't know if any of you have done any residential wiring, but #6 wiring is big. I plan on building a room on the side of my shop for a compressor, but for know, I'll be mounting it inside. Another concern is the amps it take to run this unit. I found out it runs between 23-25 amps. But, the unit will spike up when starting. So, they requirer you to use a 60 amp breaker or fuse. In my case, my sub panel uses breakers. A 60 amp double pole breaker is not cheap. I'm not being cheap, just trying to watch the electric consumption. My monthly electric bill is not cheap. Another concern, or I should say is my biggest concern is dealing with Napa. Just wondering if any of you have had any good or bad deals with buying anything of this nature from Napa. I've already searched the boards threads about air compressors. Guess I should have stated that in my first post about concerns about buying from Napa. Anyways, if any of you have any pointers, they would be appreciated.
P.S My local Napa price is cheaper than what the website states. They said they would sell it to me for $1517.00 plus 6% sales taxes, which comes up to $1608.02.
|04-18-2005 06:34 AM|
There have already been a number of very good discussions comparing various compressors here on HR.Com which you can access by using the "search" function. You can see how your's stacks up vs. others. Your stats look pretty good so I'd say it boils down to a price comparison.
|04-18-2005 04:49 AM|
Looks like a good one, it has a good motor on it, and the pump is cast iron. CFM looks good also.
|04-17-2005 11:34 PM|
well if you arent licenced to hookit up then you have to figure that into the price. i have a 5 hp 20 gal craftsman oilless 110 amp portable for now ,got it on sale .most compressor are manufacutered by the same co. an oil one will last longer and you can run synthetic oil after it breaks in anyway nice unit
good luck w/ it
|04-17-2005 10:49 PM|
Dealing with Napa on air compressor...???
Looking for opinions or your thoughts on air compressor's. Mine is down for the count and I'm looking to replace it. I'm looking at one from Napa (free shipping). I included the stat's incase the link doesn't load up. I tried it last night and it wouldn't load, site or server might have been down. Anyways, the one below is the one I'm thinking about getting. One thing Napa said, it takes a 60 amp double pole breaker to run. Which means I'll have to use #8 wire (by local code). Thats the only thing holding me back, cause thats allot of juice to run on (peak amps that is).
What have you got and are you happy with it? Have you dealt with Napa before? Like buy things of this nature before?
Attributes: Air Compressor
Gas or Electric: Electric
Stage Type: Dual Stage
Horsepower: 5 HP
SCFM Rating: 16
Maximum Pressure: 175 psi
Pump RPM: 800
Phase & Voltage: 1Phase, 230v
Motor Type: Baldor
# of Cylinders: 2
Pump Material: Cast Iron
Magnetic Starter Included: No (Napa said it's included)
Magnetic Starter Required: Yes
Lubrication System Type: Splash
Tank Type: Horizontal
Tank Capacity: 80 gal
Weight: 580 lbs
CFM Pump Displacement: 21.7