|12-15-2012 08:41 PM|
|632Mantis||I never cared for them. I don't use them.|
|12-15-2012 07:43 PM|
|1Gary||Curious.Rocker studs,roller rockers,rocker ratios??.|
|12-15-2012 12:00 PM|
|cobalt327||And you've tried them?|
|12-15-2012 11:28 AM|
I am a little reluctant to try them on modern dual pattern cam. With sharp ramps and designs looking for more power under the curve may not react well to roads lifters but havent tried it.
They do work good for long duration older style single pattern cams. But usally used in the street sizes larger cams race cams do not respond well.
|12-15-2012 10:58 AM|
same basic idea..
|12-15-2012 10:58 AM|
|12-15-2012 10:17 AM|
|cobalt327||I used a half set (the intakes only) on a Pontiac 455 w/a fairly big single pattern cam. Worked like a charm. Noise? That's music.|
|12-14-2012 04:27 PM|
|12-14-2012 04:10 PM|
|flyboy corvette||I purchased a 69 corvette 427 390 HP that was being restored and never been started since restoration and engine rebuild. I didn't know the engine builder and previous owner had installed rhodes lifters in it. Man was I shocked when it started. I thought the engine was coming apart, but it had good oil pressure. Its a very bad sound and I hate it, Maybee it will be quieter with the hood on. It does seem to have a lot of low end torque and power.I just don't think I will be able to stand the awful noise. This car has stock mufflers and is very quite so all you hear is the lifters.|
|02-23-2010 07:13 AM|
4 out of 5 posts
|02-23-2010 06:43 AM|
This guy racemaniac must work for Rhodes.
this carbon dated posting is 7 years old.
another 5 years old,
|02-23-2010 05:31 AM|
|DoubleVision||This thread is 7 years old. We should`ve carbon dated this one.|
|05-15-2003 02:38 PM|
|wally||I just took a set out of my son's ElCamino 'big block' Apparently someone tightened them too much and they [one] ate the cam...car just never sounded right like it had a knock under certain loading...seems the worn lifter might have been allowing leakage and either pre-detonation or hot air leakage anyway we put in a new performance cam and lifters and it now sounds like Chevy and run out nice. I suggest they can be problematic you gotta know what your doing|
|05-12-2003 01:20 AM|
|jimfulco||Cast aluminum valve covers quiet them down some too.|
|04-29-2003 08:20 PM|
Yay!!! I've got a set in a 390GT with over 70,000mi on them so aside from all the other favorable remarks above they last too! Put a set of 2 1/2 in. Flowmaster Header mufflers on it you'll never here the ticking, or much else for that matter!!!
[ April 29, 2003: Message edited by: 9.8sec. Hemi ]</p>
|This thread has more than 15 replies. Click here to review the whole thread.|