Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> professional products
User Name
Password
lost password?   |   register now

Thread: professional products Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-11-2005 07:28 PM
347mustang i mean less
06-11-2005 10:43 AM
MI2600 I've heard of sealing problems with their Vortec intakes, but no personal experience. For my own piece of mind, I'd rather pick up a good used brand name than trust to the Chinese clone.
06-11-2005 08:05 AM
347mustang this is a repeat but here goes my freind has a 10 sec chevy nova 2..400 chevy on noitrous..that has the victor look a like intake,..yes they have a loittle rough looking ports inside..but 10 min with a hig speed and it looked fine...for 50-80 or less than a real victor..i was im pressed with it..i also had a performer knock off..on my 427..it semmed to work fine and i installed it as it came from the factory...i would buy another one if i was on a budget but probaly a real name brand if i had lots of money...my s10 was all made up of summit brand -profisionall producst and off the wall brands and it was killer..and done for about half the cost of buying name brand parts
06-10-2005 09:29 PM
wshinn I am using their air gap clone with a 1 inch torque plate on a stroked 350 SBC. Have excellent results and very happy with the performance.
06-10-2005 09:24 PM
WakBordr7387 http://www.hotrodders.com/t62371.htm...ional+products
Its been posted and discussed before, Ive never used them. But I have seen a few of their intakes up close when they were on display and not on an engine. From what I could tell there was alot of casting flash and didn't seem as good as an edelbrock or holley to me.


Brad
06-10-2005 08:52 PM
82c10
professional products

Professional products anyone use their intakes, do the ports match up, would you buy one again

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:50 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.