|07-12-2005 10:18 AM|
If it overheated bad enough there is a fair chance you have a cracked head -- sometimes the crack is not so obvious that you would see it without careful inspection.
Please don't ask me how I know this......
|07-12-2005 09:36 AM|
Run engine to operating temps, disconnect the distributor so not to have spark, open the throttle to full open and run compression test. Results should be 179 psi with a minimum of 142psi. Hope this helps.
|07-12-2005 08:59 AM|
Ford 2.0 4 Litre Compression?
I have a 93 Ford Probe with a 2.0 lt that my daughter overheated. I have replaced the head gasket because I was told it was probably blown since there was verry little compression. I still get the same reading on my compression tester. Can you tell me what the compression reading should be? thanks