Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> installing motor with aluminum heads
User Name
Password
lost password?   |   register now

Thread: installing motor with aluminum heads Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-05-2003 03:30 PM
mac302 I would say either the leveler or the carb plate would be a good idea. But I would not pull the trans with it. Especially if the intake bolts do not thread deep into the alum. head. Hate to see anything bad happen like it did to me. Stripped the threads right out. Liked to laid down and cried when that 400 b-block fell 4 feet. <img src="graemlins/pain.gif" border="0" alt="[pain]" />
06-04-2003 08:12 PM
Bumpstick My preference is to use a carb plate... Just have the intake installed and it bolts were the carb sits... They are simple and have multiple holes to allow for balance and spread the tension out over a large area...
06-04-2003 07:26 PM
big455 I would suggest getting one of those engine levelers, they have a chain on the front and back. you connect each side of the chain to a head asc. hole . that way you have four seperate lift points, this should distribute the weight enough that you should'nt have to worry about the aluminum heads. this is what I'm going to do with my moto, I've got aluminum fastburn heads from GM on a 383.
06-04-2003 06:34 PM
JH30906
installing motor with aluminum heads

This is probably a stupid question to most of you but i'll ask anyway,{I'm still learning}. Where is a good spot to attach the motor hoist if using aluminum heads. When i pulled the old motor i bolted a chain to the accessory bolt holes on the cast heads and pulled the motor and tranny together, is it safe to do this with aluminum heads or should i attach to something else.Its a 383 with th-400. Any suggestions would be greatly appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:25 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.