Hot Rod Forum banner

67 Mustang Fastback shock tower hat

2K views 2 replies 2 participants last post by  AngliaBob 
#1 · (Edited)
I hope someone can help me, I've been searching the net for days trying to find the correct hats. Please refer to the crude diagram below.

The center to center measurement on the top of the shock tower is 3 /3/4 (b to c) for the body side bolts and 4 1/4 from either outside bolt to the engine side bolt (b to a) or (c to a).
I have 2 sets of hats, but both measure 3 (b to c) and 4 (b to a) or (c to a).

I have found a 69 GT500 with the same pattern, but can't seem to find them anywhere on the net. Distributor,part name or part number would be most appreciated.


(engine)

(a)


(b) (c)

Thanks,
Bob
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top