Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> '61 chevy rear end
User Name
Password
lost password?   |   register now

Thread: '61 chevy rear end Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-10-2002 05:05 PM
BOBCRMAN@aol.com this is the old style rear that chevy used from 55-64, they had a lot of axle bearing and seal problems, there is a replacement sealed unit that you use with o-rings and silicone but i haven't seen one in years, the axle specs would only be in an old service manual
12-10-2002 05:01 AM
oldtimer
'61 chevy rear end

I've replaced the drivers side bearing twice now (going for a third). It starts leaking after awhile (few months), the shaft has no groves worn in it, the housing looks good. This rear is like a 9" and the bearing has to be pressed on the shaft, also the bearing has 2 "o" ring seals around the outside to seal it against the tube. the pass. side I replaced before and it doesn't leak. Anyone have some ideas ? (could the machine shop be tweaking the seal alittle so it will leak, or am I missing something). Is there any specs on the i.d of the tube or the o.d of the shaft.
Thanks in advance.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:54 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.