Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Garage - Tools> Plumbing Compressor....
User Name
Password
lost password?   |   register now

Thread: Plumbing Compressor.... Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-07-2005 10:17 AM
70Shorty
tape it

For a air line,, I'd just use the tape, keep it back from the end a thread or so and you'll be good to go. It's only air for pete's sake,,,

12-07-2005 09:25 AM
Huskinhano Off hand, I think not. Since the line will be pressurized, I don't see how anything could migrate in. I'd also try to keep the sealant away from the begining of the threads and only on the threads that are going to be engaged.
12-02-2005 06:06 PM
Rob Keller might be best to not get any to close to the end of the pipe like a thread or two.

use the same principle with Teflon tape leave it back a thread or two and you will never get any loose tape clogging up a valve ,check valve or a screen

pipe dope will weep a little when it gets warm(i think)

good luck

SR66

__________________
I'm not prejudice, I hate everyone
12-01-2005 09:48 PM
PairOf69's
Plumbing Compressor....

I'm in the process of plumbing my new compressor, I got 3/4 galvanized pipe. I'm using T Plus 2 teflon sealent on the threads I was wondering if this stuff is going to screw up my water seperator/paint hose?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:30 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.