|02-23-2006 04:17 PM|
|slege||Thank you. That was exactly what I needed.|
|02-23-2006 08:53 AM|
|yesgo||hope these help. they are GM 9.5" rear 67-81|
|02-21-2006 04:18 PM|
not a retard
Given the opportunity to view one side done correctly would have made this project too easy. One of the "old timers" removed the adjusters just like the ones in the old days. Thanks for your insight.
|02-21-2006 12:58 PM|
|xntrik||Good procedure, passed on from old-timers..... only disassemble one side at a time.|
|02-20-2006 04:22 PM|
On on the hardware I bought to put in my car, there is a piece of wire (similar to #9 wire) that is bent. I have seen them used before but I don't remember where it goes, can you help. I think I can get the rest with that information. Thanks
|02-17-2006 02:59 PM|
|poncho62||The Pontiac wont have the cable for the adjuster.........it's a lever type.|
|02-17-2006 02:34 PM|
As a moderator here, I would like to WELCOME YOU here..
This is a Ford backing plate with the self adjusters........not a Pontiac but they are basically the same.........and should get you started in the right direction.
|02-16-2006 07:43 AM|
1967 Pontiac GTO brakes
Does anyone have an illustration on how the rear brakes are assembled? I had none of the adjuster hardware on my car when I got it.