Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Swaping in a 9 inch
User Name
Password
lost password?   |   register now

Thread: Swaping in a 9 inch Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-14-2006 02:44 PM
Deuce In my part of the country....it would be a lot less expensive to just get another, more narrow rear end than shortening the one you have.....

I had a 55 Chevrolet pickup ( 2 nd series ) ...same basic truck as your 57 and I used a 69 Torino....it was just a bit over 59 inches wide.....measured this way.....



It was almost 3 inches more narrow than the stock rear end....total
It worked great.......it was like having a stock rear that was narrowed 1 and 1/2 inches per side...... I like to run a 3.25 or a 3.50 rear end ratio.....because I usually have tires in the 29 to 30 inch tall range....that's 2700 rpms at 70 with a 30 inch tall tire...anything less.......and the lumpy cammed engine is lugging....

03-14-2006 08:28 AM
lbell101
Swaping in a 9 inch

I've finally got ahold of a 9 inch rear for my 57 chev truck project.
But now I need to make some adjustments. So 2 questions:
1)The original rearend is about 62" flange to flange while the new one is 65" roughly. Should I have it narrowed to the original dimension or something different? Or leave it alone?
2) The new rear has 2:75 gears. What do you guys think is optimum for weekend use to and from shows with some freeway driving? It's a 500 hp 454 mated to a T400 transmission.
Thanks!

Larry

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.