|11-08-2001 04:13 AM|
|Phat||Just a thought look at corvette spindles from the early cars.I think they may just bolt on with disc and all. I seem to remember the spindle is the same style but i had to adapt the rear wheel bearing and after all the work noticed that the whole spindle with brakes worked . i did this a long time ago but check it out.Look to see if your balljoint points down with the spindle under the lower control arm(like the vette) I find the earlyer vette stuff pretty cheap(cause spindles dont get checked for matching # LOL )|
|11-08-2001 12:15 AM|
Have you talked to -Master Power Brakes-?
They can make adaptors to fit calipers to your spindle. They also offer a kit for a 1961 Chev. Maybe they can adapt the kit to a Pontiac.
|10-28-2001 01:29 AM|
It is usually cheaper to go the kit route rather than utilizing take-off parts from a later model-
-Stainless Steel Brakes-
-is one such supplier.
|10-25-2001 03:03 PM|
disc brakes for 1961 Pontiac catalina
Does anybody know what disc brakes will fit on this car?