Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> no reverse
User Name
lost password?   |   register now

Thread: no reverse Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-21-2006 03:43 PM
no reverse

thanks for the help,I will pull the valve body off first and look before I pull the trans and go in it again.
05-20-2006 01:04 PM
no reverse

cant think of anything, maybe ck ball not installed in the right place
05-20-2006 08:53 AM
no reverse

I checked the fluid,it is good and as far as engine breaking,from 2 to 1,its great. when I first started it up reverse was the first gear I went too,could there be trash in the valve body,and it held long enough to back off the ramps,and worked a little while it was cold,but now nothen.thanks for all the help.
05-19-2006 06:22 PM
no reverse

how is engine braking effect when downshifting 2nd to low?
my first thought on this would be popped out the snap ring holding low roller in place, low reverse clutch plates. if thats not it the only other thing I can think of is a cut sealing ring for reverse input drum but that will cause no reverse and still have engine braking 2nd to low gear.
05-19-2006 03:01 PM
scrot Double, tripple check the tran fluid level. With fresh fluid, it can be very hard to see the correct level. If the fluid smears all over the dipstick as you pull it out, you might think you have it filled up, but you are in reality low.
05-19-2006 02:22 PM
no reverse

I just rebuilt my 700 R4 and put a new 2500 stall converter.I went through all the gears when I filled it up,reverse grabbed at first but now,nothen,this hasn't been my first rebuild,but I cant figure it out,any Ideas?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 08:39 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.