Hot Rod Forum banner

pete jackson gears

2K views 2 replies 3 participants last post by  xntrik 
#1 ·
Where should the timing marks be on a pete jackson gear setup on a small block 400??
 
#2 ·
bekkaboo said:
Where should the timing marks be on a pete jackson gear setup on a small block 400??
Dot to dot , big drive gear on passenger side,little drive gear on driver side, dot on cam at 6 o'clock dot on crank at 12 o'clock , and that is not to be construed as being #1 TDC firing , because if you rotate crank 360 degrees the cam dot will be at 12 o'clock also and the motor is still in time. Thus this is only cam to crank timing.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top