Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> driveline angle issues....
User Name
Password
lost password?   |   register now

Thread: driveline angle issues.... Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-03-2006 07:57 PM
carnuck I do 4x4 stuff and the way we cure these issues is with a fixed yoke trans output and a driveshaft with CV joint at the front, and tipping the differential so it is pointing directly at the trans.
Check out Tom Woods for high angle shafts.
07-03-2006 10:47 AM
gdubstub Another good site is www.iedls.com, Inland Empire Driveline Service. They have a great tech section that explains all the geometry you need to employ in a driveline setup.

George
07-01-2006 03:13 PM
powerrodsmike you can get 2*(and I think 4*) shims from any speedshop, 4 WD shop or mailorder catalog. If your pinion angle is out of alignment with your trans output shaft by more than 4* I would redo the spring perches.
Here is a link to the section in the KB with several articles that explain why proper phasing and angle is important.http://www.hotrodders.com/kb/browsel...atid=55&page=2
Hope this helps,
mikey
07-01-2006 01:57 PM
joe350s10
driveline angle issues....

I recently discovered...much to my shagrin...that i have twisted the driveshaft in my truck 8 degrees off center.
Of course, I will be buying a new driveshaft soon...but I have a quick question...

Due to the fact that I shoehorned the V8 into my s10, I don't have alot of adjustment when it comes to the tranny to rear end angle.

the tranny is angled up as far as it can be but it is still no where near the same angle as the rear end.
It has been suggested to me that I could either add wedges to the rearend mounts to turn the nose up to the correct angle or cut the mounts off and reweld them in the correct position.

So, has anyone else had this problem?
How did you choose to fix it?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:15 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.