Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Rear end identification
User Name
Password
lost password?   |   register now

Thread: Rear end identification Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-25-2006 11:12 PM
jimfulco Leave one wheel on the ground, then rotate the other wheel TWO full turns while you count. This will give you an accurate number. If you lift both wheels, the wheel you can't see will turn a little (or a lot) in the other direction and screw up the count. If you have one wheel down and rotate once, you need to double the number to get your ratio.

I believe 3725899 is an old Chevy car rear end with the drop-out center section. That type of rear end was used from '55-'64, with different widths & spring mounting hardware for different cars.

Google 8725899 rear and there's an old ebay listing with pics. Casting numbers are often mistaken, especially if they're old, rusty, dirty, etc.
08-21-2006 07:03 PM
49dream Plmouth coupe

I did what you said and tuned the wheel 1 full turn. The drive shaft turned
1 & 5/8 times. Are you saying i have a 1.625 ratio ?
08-20-2006 01:16 PM
Jon Check the Hotrodders Knowledge Base first, that's the most likely place to find a rearend identification guide for your vehicle. Here's the relevant category: Transmission-Rearend Technical Data.
08-20-2006 12:40 PM
37 plymouth coupe
ratio

jack up the rear of the vehicle. Mark the right rear wheel and the driveshaft. Rotate the wheel 1 full turn and count the the turns of the driveshaft. DO the math (divide)= ratio
08-17-2006 06:56 PM
49dream
Rear end identification

I have a 49 Chevy pickup with a GM 10 bolt rear end

The number on the rear end is GM K11 8725899

Is there some where or some one that can tell about this rear end?
Maybe the the year or what this rear end came out of.
The gear ratio would be beneficial too.

Thanks
Marcus

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:57 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.