Hot Rod Forum banner

Transgo Mod - Rear Servo Washer Stack

1K views 4 replies 3 participants last post by  paulo 1 
#1 ·
I posted this on the tail of another thread, different issue, but re-posted here hoping someone will respond. I tried to call TransGo tech but no answers, probably too late in the day.

I bought a full manual Transgo-S kit but have an issue with the rear servo modifications. I removed the inner spring, seat and e-clip and installed the six washers as directed. I cannot get it even close to meeting the mounting surface with the cover, so started removing washers. Long story short, to get the cover to mate I removed all but two (leaving the original washer). Now I need to remove two additional to allow for band clearance. Heck, that puts me back to the stock configuration only with no spring and seat! I even removed the O-ring to ensure I was pushing it all the way up.

Anyone installed one of these kits? Am I missing something?
 
#3 ·
Thanks for responding, I understand the instructions - I think! It's pretty cut and dried the way it's presented.

It just seems odd that I wouldn't need any of the supplied spacer washers to make things fit back together. I've darn near sprained my neck and shoulders pushing up on the servo piston trying to make it mate! Even removed the O-rings to loosen things up for trial fitting.

Did they tell you any black magic or anything?

This is a '75 T-400.

Larry
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top