|09-21-2006 03:42 PM|
Carb size is about right for the type of driving you are doing.
|09-21-2006 12:47 PM|
|onovakind67||Suggestion #1 - add the proper vacuum advance to your distributor, it will increase the VE of the motor while you are cruising. I don't think the carburetor is much into the equation at this point.|
|09-21-2006 11:46 AM|
327 sbc carb size ?
I have a .040 over large journal 327 in my model A hot rod, 350 transmission, 3.00 geared nine inch rear. Motor has, 4.65 lift cam, MSD ignition (no vacuum advance), performer aluminum heads (70-170), performer manifold, 600 cfm carb, lakester headers. I have 2500 miles on it since May when I finished the build. So far I'm happy with the results. We just put 600 miles on it, my gas mileage was appoximatly 15.5. The timing is 32 total (12-20). I know it's running a bit rich. I changed jets and rods as per Edelbrock chart but it seems to run best at factory settings. I'm wondering if a 500 cfm carb would be more suited to this motor? I was running about 2650 RPM to get that mileage. Any suggestions?