Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> anything better than oven cleaner?
User Name
lost password?   |   register now

Thread: anything better than oven cleaner? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-22-2003 05:28 PM
Axelrod I have never had any problems with pressure washing, I use the 25 cent car wash which I believe is around 1200 lbs psi. Obviously you have to use some common sense and keep the tip back away from some areas. I wouldn't put it up close on anything electrical like an alternator. Like I said in my earlier post I've had good luck with this method. The only side effect I ever experienced was a set of soggy plugs in an Acura that apparently leaked past the boots causing some sputtering, DOHC set up. A quick blast with some air cured that.

spl_dodge, I like the No-Touch tire cleaner and dressing. Not as wet looking as some products and doesn't seem to attract dirt. It also make the tires easier to clean the next time. I have never thought to use it anywhere else. Thanks for the tip.
05-22-2003 09:27 AM
spl_dodge Use a degreaser and let it sit for a few minutes before spraying it off. DO NOT USE A PRESSURE WASHER!!!!! It will get into every nook and cranny and possibly mess up the engine.

Be extremely careful when using a degreaser - DO NOT GET IT ON THE PAINT!!!

After you have successfully degreased the engine, spray the engine with no-touch tire foam. It will make the engine bay look brand new.

I use no touch on my inner fender wells and frame and suspension components too - makes them look new without having to re-paint for every show
05-21-2003 05:37 PM
Axelrod If Purple Power strips paint I don't think you would want to risk messing up your new paint job.

I have used Gunk many times over the years to clean up an engine compartment. If fact, I use it every spring to clean the engine bays of our daily drivers. You don't have to worry about it messing up your paint job, just try to minimize sloppong outside of your engine compartment. It works best if the engine is completely warmed up before you spray it on. Leave it set a couple of minutes and then pressure wash the engine compartment working from top to bottom.

If your engine has the original paint you might find some of it comes off when power cleaning but you can always carefully detail and paint after cleaning. Not the easiest thing to do but if you take your time, mask carefully and then install new wires, plugs and remove and repaint brackets and pullys, etc. you should end up with a really nice job. Don't worry about any paint you might get on the cast iron manifolds. They painted them from the factory with the engine but it burns away very soon. Use Calynx dressing to detail the cast iron manufolds after the paint burns off.

Don't use gas, you don't want to risk a fire. Good luck.

[ May 21, 2003: Message edited by: Axelrod ]</p>
05-19-2003 08:00 PM
s15laynrubba I used the purple power from advance to strip the paint from my vette back in '98.I am using it now to strip the paint on my truck.Strong stuff
05-19-2003 03:47 PM
Mirror Image [quote]Originally posted by PUSHROD:
<strong>Try using purple power it will take off about anything!!!!!!!,or gas works pretty good too</strong><hr></blockquote>

yeah man purple power works great you can get it at Advance auto parts
05-19-2003 12:13 PM
PUSHROD Try using purple power it will take off about anything!!!!!!!,or gas works pretty good too
05-19-2003 08:14 AM
78novaman try Gunk engine degreaser, it takes about anything off, however it might take the paint with it so be careful.
05-16-2003 08:09 PM
anthony herrera
anything better than oven cleaner?

i just had my 68 suburban painted,now i want to clean up the under hood and engine. i have used oven cleaner and a pressure washer but it's not cutting years of dirt and grime.time to bust out the wire brush and 12pak or do you have a plan B for me?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 04:47 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.