|02-19-2007 04:19 AM|
I used reversed eye springs on the front and lowering shackles on the back, 215-60 series tires on the front and 295-50 series tires on the back. The truck still rode just fine and I got about 6" drop in the front and 3 inch out back. Don't torch the springs or remove leaves, it only compromises the ride and may affect the safety.
|02-17-2007 08:03 PM|
Another CHEAP way is torch the springs until they sag till the axles set on the snubbers.
Another CHEAP was is get four of those real small spares from the pick-it-yourself yard. (I have seen Ricers do this one.)
On a serious note: ALL the posters suggestions above are good. You just need to decide how deep your pockets can let that 56 drop.
|02-16-2007 09:52 PM|
I saw a low f100 in Kamloops B.C. they had mounted the body on an s10 frame with dropped spindles. They said that all the body mounts lined up except for two. Truck looked like it could mow the lawn.
|02-16-2007 07:33 PM|
|02-16-2007 05:59 PM|
How much do you plan on dropping it?
If you stick with the I beam axle in front the best way would be to get a dropped axle. You could also have the eyes reversed on the springs to get a bit of drop.
On the rear if you want to go really low you would have to put the axle on top of the spring. Then you would need to C-notch the frame for clearance.
I've seen a few front axles put on top of the spring. It isn't hard to do but you could end up with the springs too low to the ground with low profile tires.
Low profile tires like 205-60-15 on the front and 245-60-15 on the back will bring it down a bit and get the stance right.
|02-16-2007 04:52 PM|
Don't be a cheap john, save your money until you can do it right.
There is no hurry, the 56 is the best looking of all the F100s and everybody likes 'em no matter how they sit!
Don't do something that will get your truck featured in "poor worknanship" posting.
|02-16-2007 12:15 PM|
low and cheap
|12-12-2004 06:56 PM|
The cheapest way is to put the axles on top of the leaf springs. front and rear. And the front mounts for the rear leafs can be moved up for more drop.
You won't have a lot of suspension travel this way, unless you notch the frame, front and rear.
|12-12-2004 05:46 PM|
1956 Ford pickup
Can anyone tell me what the cheapest way to lower a 1956 ford pickup front and back. Thank you!