|03-17-2007 09:14 AM|
|machine shop tom||
|03-17-2007 09:06 AM|
|03-17-2007 01:25 AM|
Build for 91 octane reliably you want a true 9.5:1 or alittle less. Use GM 350 5.7" connecting rods. use ARP rod bolts. A few of the rod bolt heads will contact the cam lobes. You have to grind the rod bolt head edge to allow .030" clearance minimum on a few of the rod bolts when using GM 5.7" rods with a 400 crank. The machine shop can take are of this for you or you can do it yourself. Requires mocking up the block, crank, rods, pistons and camshaft. I usually borrow a big race roller cam (260+ dur@.050) to do the rod bolt clearancing so that any street sized cam that the motor will see in the future, will fit with out rod bolt head interferience.
Use Keith Black Hyper KB -168+.030 22cc D dished pistons. You must set the top ring end gap large. .032" is not too large for this type piston.
it is just right for this hyper piston and mild N20.
With a non decked 400 block and felpro .039" 400 gasket your cr will be 9..30:1... with a cleanup cut on the block (.005") your cr will be 9.4:1. I would not go higher.
The above mentioned Comp XE274H10 will work well with a Performer RPM manifold.
The heads must be drilled for the extra 400 steam holes.
The Stock GM 400 cast crank is plenty strong.
The bottom end assembley must be rebalanced.
Are your TFS heads the 23deg heads or the "Twisted Wedge Heads"?
|03-17-2007 01:03 AM|
|327NUT||Is Anaheim too far away for you??|
|03-17-2007 12:29 AM|
You should try this
hyperutectic pistons,with moly rings
6" I-beam rods with arp rod bolts
274H xe cam
gear drive or double roller timing chain
1.6 roller tip rockers
Performer rpm intake
670cfm street avenger holley
hei igntion 50k coil
keith black pistons(KB130)
I-beam 6" con. rods
|03-16-2007 11:07 PM|
Recommend me a build! 400 sbc, 64cc heads
So, this is my first sbc build - and I need some help! I've got a '70s 400 sbc 2 bolt short block, and a set of bare Trick Flow aluminum heads with the following specs...
I have a '63 C-20 I can drop this into but if this turns out to be a sweet little motor I'll stick a Goodwrench 350 I have hanging around in the truck and find a nice little 2 door for this 400.