Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Electrical Problem
User Name
Password
lost password?   |   register now

Thread: Electrical Problem Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-10-2007 09:37 PM
headturner73
Electrical Problem

Well guys this is what I came up with,,could not get fireing on rt. side Chevy
383 so,,,I went back to base one,,,removed the dist. since it was double points I switched them,,,but,,found,,both sets were shorting and new cap had a hair line crack,,put old cap back on and reset points ,,fired right up,,but still don;t have the power it had ,,,so,,I decided to go with PERTRONIX BILLET DIST. and Flame Thrower 2 coil,,so thanks for all your help and I will see how this unit works out,,o- yes I will keep my points close by,,,Thanks again,,Brian
04-07-2007 08:18 PM
docvette Doc here,

Very ODD indeed!

I Don't think I have ever heard of a BANK of plugs going out and the other working fine..(assuming you checked 2,4,6 and 8 for fire, not just 2...)EVEN with one set of points firing, it should hit on all 8...

Try running a battery jumper cable from the battery , insert the spark plug BODY into the other clamp put on each plug wire and look for spark ... (you can hold it in your hand without getting bit this way *AND* you have a Bonded ground without having to "Just get it close to the block..!)

TRY running a Ground strap (or jumper Cable) to the passenger head from battery ground..and see if spark returns, maybe the head is insulated by gaskets and sealers and the change of the manifold sealed (pun intended) the right head's fate as to a proper ground bond..

One other thing , It may be possible that in changing the manifold, you may have dropped Or rested the manifold (or other heavy part) on the plug wires for the passenger bank..and internally cut the cores..Try new wires or swap in some known good ones.

Other than that, unless you have a Crossfire cap..I can't think of anything that would effect plugs 2,4,6 and 8 in a row..since the FO (Assuming SBC) is : 1,*8*, *4*, 3, *6*,5,7,*2*..It (the Dizzy) would have to do a lot "OF SKIPPING around to miss the four in a row..(astric's are passenger bank)...

Keep us updated..

Doc
04-07-2007 05:44 PM
T-bucket23 I would check both sets of points since you said it was ok before and you "adjusted them and now you have issues. The point gap should be about .017 with the rubbing block on the lobe of the dist cam.

Good luck
04-07-2007 05:31 PM
headturner73
Electrical Problem

Hi Guys,,here It Goes,,73 Nova With A 383 ( 350 ) Stroker Had To Replace Intake Gaskets,pulled Dist.out ,,and While I Had It Out I Checked Points For Proper Gap Needing Adj. The Dist. Is A Mallory 2548201 With Double Points #25042x ,, The Points Are 6mo.old And Cap And Rotor, And Plugs,,got It Lined With # 1 Plug,,fired Up And To My Surprise Only Driver Side Had Spark,i Checked To Make Sure I Had Fuel And Plugs Were Wet,checked Cylinders 125 Plus Lbs,i Took A Plug Wire Off Passenger Side Stuck A Spare Plug In But No Spark,could It Be A Bad Set Of Points Or Something In The Dist. I Also Put A New Starter In,turns Over Well,i'm Ready To Go Electronic But I'm Hearing To Many War Stories,,any Help Would Be Gratefull,,thanks Brian

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.