Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> cleaning a gas tank
User Name
Password
lost password?   |   register now

Thread: cleaning a gas tank Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-17-2013 12:39 PM
tresi I'm not going to argue about poured in sealer being good or bad. I've seen good and bad results. But if you do try it the tank must be totally clean, no short cuts. if not it will come loose inside the tank and you'll never get all back out.
03-17-2013 10:08 AM
airbrushguy m.e.k. solvent???
06-08-2007 02:35 AM
tattootravis
gas tanks and rust

muratic acid in the tank will eat the rust and m.e.k. sovelt [dries it out] after water plume.its cheap and sold at lowes for 5 a gallon,they use it in bleaching pools and sidewalks......does real goood on my motorcycle tanks!
06-07-2007 10:30 PM
techinspector1 If the tank is rusty, use the gravel as was mentioned by curtis73 or you can also use a length of chain to slosh around inside.
06-06-2007 11:02 PM
bartamos I put clean rags in stuff like that and let them do the cleaning. Slosh it around with whatever fluid you use. It's not hard to fish them out.
06-06-2007 10:52 PM
curtis73 If its really bad here's what I do. I put a few handfuls of 2B limestone gravel in the tank along with about a quart of acetone. Get you and a buddy to slosh the snot out of it. The acetone dissolves the gunk and the stone gets the stubborn stuff. Don't worry, the stone is big stuff, like the size of the end of your thumb and its not "dirty" -- as in having lots of stone dust and little bits along with it. Its just big stuff so its easy to get out and easy to tell if you've missed one.

I've also had pretty good luck sticking the nozzle of a 3500 psi pressure washer in the filler neck, but since you can't be assured of hitting all the gunky stuff it never inspired much confidence.
06-06-2007 03:08 PM
bourne51
cool enought!

bourne51 here.......i use two filters on my gas line i have found that sealing a gas tank makes it last a very long time,and i have not had any problems with it and i dont let me fuel run to empty(well not usually),but i will take note on what has been said on this gas tank blog!!!!!!!!!!!!.........
06-06-2007 01:58 PM
gcrmcc If the tank comes out really clean there is no reason to use a poured in tank liner. I would not reccomend using a drain plug with a coupler for the fuel pick up. In reality there should be a gallon or two of fuel that is not usable below the fuel pick up. The sediment in the tank will sit at the bottom. If you make all fuel usable then all the trash that is pumped in at the gas stations will plug up filters and possibly go through the fuel system. also condensation will stay at the bottom and not be picked up if a few gallons are not usable.

gcrmcc
06-06-2007 09:43 AM
bourne51
1/2 right!!!

home brew got it half right!......after the boil-out then put a alk.restant plastic sealer inside,(they do it at most rad.shops-for gas tanks),then what i use is a spigit at the bottom,(drain plug),put on the far left or the far right,of the gas tank.after that is done figure out the best way to set up the gas pick up or just use the spigit end and use a cuplink to make a gas outlet.you hook up you gas line from there.i do this because the lowest part of the gas tank is the lower outlet(spigit),make sure before you do the finial hook up you clean and blow out the remaining gas line,and you sperated the line from the gas pump,before you cleaned and blew out the line!!!!!!!!!!!(bourne51)..
06-06-2007 09:13 AM
home brew The easiest way is to take it to a place that rebuilds radiators and have them put it in their cleaning vat. It will come out sparkling clean. Or you could check out all the suggestions in this thread that I found by typing in "clean gas tank" in the search funtion on this site (link towards the top of the page):

http://www.hotrodders.com/forum/carb...clean+gas+tank
06-06-2007 08:49 AM
boatbob2
gas tank cleaning

Hi,i had a gas tank in a boat that was really filthy,very bad gas. i drained the tank,put 1 gal of acetone in it and sloshed it around,did the same 2 more times.then shone a flashlight inside tank,to make sure it was clean. then filled tank with soapy water 3 or 4 times,sloshing it around . then turned tank upside down,drained and flushed tank with clean water. after draining as much water from tank as possible,i left the tank in the sun,with the cap off until it dried. worked great.
06-06-2007 08:06 AM
Tryin2MakeIt
cleaning a gas tank

what is the easiest way to clean a gas tank. i have a truck that has sat and had gas in it for 6 years. that gas stinks and wont burn

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.