Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Fenderwell headers
User Name
Password
lost password?   |   register now

Thread: Fenderwell headers Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-09-2008 03:27 PM
henny496 Thanks very much for your replies
After looking around at some companies and the fact that my engine placement is not in the factory position, I bought a bunch of J bends , tubing and the alignment sleeves from Hooker
I will make them, so in a few months I will hopefully be able to post a pic of the outcome
thanks
Tom
01-07-2008 05:39 PM
Brian_B I am not real sure what you are looking for, but you might take a look at this thread:

http://www.hotrodders.com/forum/55-c...re-130937.html

The 55 chevy has home made fenderwell headers.
01-07-2008 05:25 PM
richard stewart 3rd Hi Tom,
You'll be able to get a kit made up
for your car, you'll need to call them,
but for what there going to cost, I would
make my own.
Good luck,
rich

http://www.sandersonheaders.com/cust...41ad5e1de9c6d4

http://www.stahlheaders.com/Frame%20New%20Drag.htm
12-09-2007 01:33 PM
henny496
Fenderwell headers

Hello
I am building an old vette with a BBC in it for street/strip. I have modified the chassis quite a bit so I don't have room to go under the floor pans
I bought a Hooker kit and tried to go over the frame and out the sides, but it is getting messy
Is there a kit for fenderwell headers for a BBC? I cannot use the standard Hooker side exhaust either since my engine is centered in the car and on a lower angle( I tried)
I don't have the factory brkts for the motor mts and the master cylinder is under the floor in front of the seat
I just need some tubes, but it would be nice if some kit was available, otherwise I will just have to make it......(more time)
thanks
Tom

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.