|12-24-2007 07:12 AM|
heres what i got
Cola forged crank
titanium 5.7 rods
wisco forged pistons
Brodix SPEC heads
2.06 intake 1.60 valves (titanium)
Isky Racing Cams
Cam Style: Hydraulic roller tappet
Basic Operating RPM Range: 3,000-7,000
Intake Duration at 050 inch Lift: 238
Exhaust Duration at 050 inch Lift: 248
Duration at 050 inch Lift: 238 int./248 exh.
Advertised Intake Duration: 284
Advertised Exhaust Duration: 294
Advertised Duration: 284 int./294 exh.
Lobe Separation (degrees): 110
Intake Valve Lash: 0.000 in.
Exhaust Valve Lash: 0.000 in.
Grind Number: RR-284/294
crane rev kit
1:5 ratio roller rockers on exhaust
1:6 ratio rollers on intake
super victor intake
AED 850 DP carb
(only thing I changed was the cam and rockers)
the motor was a backup IMOD motor.
|12-24-2007 05:51 AM|
I agree but I would go for flat top pistons instead of dished. No need to give away compression. Pump gas will work close to/up to 11:1 cr. Especially if you go with aluminium heads.
A solid short block is always a good idea, but if your crank, flywheel, rods, etc etc are in good condition I wouldn´t bother converting to internal balance. Not for 350hp anyway.
|12-23-2007 10:20 PM|
|Canadian78||Thats for the help.|
|12-23-2007 10:19 PM|
you can do quite a bit with $3000. If you have committed to this amount have the block bored, line honed and decked.
Get a nice internal balance crank and dish top pistons. Decent aluminum heads can be found on ebay for $800 or less, a 185-200 cc runner will be ideal, I'd like the 200cc's personally. Air gap intake and a cam with around 235-240* @ 050 and as close to 500" lift as you can get with that duration. 2500 stall and it will make serious power. Basically what Stroke said
|12-23-2007 09:39 PM|
|12-23-2007 09:33 PM|
|12-23-2007 09:04 PM|
|NXS||what do you want to do with it? what vehicle, gears tranny? octane?|
|12-23-2007 09:03 PM|
400 sbc builds.
I got my 400 the other day. Trying to get a idea on what parts to use. What kind of builds do you use with your 400?
Looking to get around 350-400 hp/tq at least. My budget is about 3 thousand maybe more.