Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> roller cam retrofit
User Name
Password
lost password?   |   register now

Thread: roller cam retrofit Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-28-2008 10:08 PM
curtis73 Be prepared for wallet shock. Things don't seem too bad, but when you add it up it can easily cost $850 for a full retrofit.
02-28-2008 07:17 PM
y112
roller cam

As far as any roller "fitting", they will. Some people think that the newer factory ones won't fit the older blocks, but that is not true. The factory cams have a smaller diameter end that was machined for the factory retainer plate that bolted to the block. The overall length is the same. Anytime you use a roller, you must control the endplay of the cam to prevent the roller lifters from hitting the adjacent lobes. This is done with a cam button on the older engines and a retaining plate on the newer engines. You can use a cam button on a newer factory roller in an older block.
The timing gears fit the same.

If you use a hydraulic roller in an older block, YOU MUST use the aftermarket lifters because the old blocks are not machined for the newer factory lifters and retainers.

You MUST match up components for the blower motor and I highly recommend calling one of the several tech lines available through Crane, comp cams, Lunati etc. for the best selection. So-called dumb questions are a lot cheaper than a mis-matched engine that runs like a pig.

After you determine how your vehicle will be driven most of the time, then you can start putting your plan together.
Tire size, gear ratio, trans, vehicle weight and rpm range info will be needed before you call the tech line.

Don't forget to consider the strength of the rear, trans, and axles that you will be using with the blower.

Hope to see some photos!
02-28-2008 07:12 PM
PatM If the original engine came with a roller cam, do not use a retrofit. If the original engine came with a flat tappet cam, use a retrofit roller. Naturally, this all assumes that you're not specifically modifieing the block at the machine shop for the OEM type cam configuration.

Pat
02-28-2008 06:28 PM
smokin63
roller cam retrofit

I have a SBC 350 I am putting together , I want to convert it to a roller cam and its going to be supercharged . Will any roller cam work or is there something paticular about the ones labled as a retrofit ?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.