Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> SBC intake bolts
User Name
Password
lost password?   |   register now

Thread: SBC intake bolts Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-27-2008 07:36 AM
Mike H If it was a TBI engine it is not a Vortec head so you will have to do a little grinding or mill work on the 4 centers. The Vortec's were the ones with the plastic upper intake.
05-27-2008 07:20 AM
Cape Cod Bob Thanx, I'll check on the Vortec vs non Vortec. This 350 is out of a truck and the throttle body has been removed ,so I think it is non Vortec . I haven't seen the motor yet. I was thinking of using my carb and intake.
Thanx.
05-27-2008 01:23 AM
SSedan64
Quote:
Originally Posted by Cape Cod Bob
I know I've read here that I can put a vintage intake manifold on a late model 350 that has angled bolt holes,TRUE?
Can I also use my vintage distributor?
'90 sbc late 60's intake dizzy and water pump. etc.
Thanx for any help
Are you referring to the 86,87 up heads with the 2 center bolts at a different angles or Vortec type heads? If NonVortec style heads the center holes on your intake can be ground to work with newer heads. If Vortec style I don't recommend drilling those for oldstyle intakes because of sealing problems. Distributor & waterpump should be fine.
05-26-2008 10:46 PM
Cape Cod Bob
SBC intake bolts

I know I've read here that I can put a vintage intake manifold on a late model 350 that has angled bolt holes,TRUE?
Can I also use my vintage distributor?
'90 sbc late 60's intake dizzy and water pump. etc.
Thanx for any help

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.