hello i am new to this lil forum. i don't know too much about mechanics, but does anyone know what i'll all need to do a pulsar 1.6 to 2.0 swap, i've been told and axle carrier bracket, engine cross member, compu, wiring harness, motor mounts. i don't know what a good price to pay for a wiring harness is either nor if these are all the parts i require. so if anyone is more knowledgeable at this and wants to give me a heads up, that'd be great...

dm

go find a nissan message board or a ricer board.

True, you're in a hotrodding site. But most here done mind helping out the blind and the misinformed. The Nissan Pulsar 2.0 liter is not just a bigger engined vehicle, it's has a beefed drive train, cooling system, fuel supply and possibly brakes as well. My tip would be to buy a half cut car from Japan complete with power train, electrics, etc. It would be one of those operations that would warrant having a donor vehicle on hand to supply you with any big, and little, part that you may have over looked before tackling this operation.