I painted my frame last week in Nason base/clear urethane. It turned out very nice, except I noticed a few spots on the underside that did not get enough base!
Can I just scuff and re-shoot the base and then clear again?
If it helps, here is what I used.
Nason ful-base black (mixed 1:1 w/ful-base reducer 441-22)
Nason Select Clear 497-00 (mixed 3:1 w/ activator 483-79)
The frame is a frame that I built for my '57 Belair. It is setup for an LS1 motor and corvette C4 front and rear suspension.