|
|
|
01-03-2009, 04:33 PM
|
||||||
|
||||||
|
Being a Tool & Die maker, I'll tell you right now that you won't bend it 90 with sand and duct tape. You need a set of dies to do it correctly, but like kruzr stated...buy a 90* bend and weld and dress it off.
|
|
01-03-2009, 08:37 PM
|
||||||
|
||||||
|
Quote:
Shane
|
|
03-31-2009, 02:11 PM
|
||||
|
||||
|
this place has the bends yer looking for ...they will save you cash in the long run..
mandrel-bends.com
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to DIY Exhaust pipe bending | ChrisMiddleron | Engine | 19 | 11-21-2012 04:35 AM |
| Exhaust Diameter Formula | ChevelleSS_LS6 | Engine | 11 | 04-27-2012 09:21 PM |
| trans cooler | tomco550 | Transmission - Rearend | 1 | 10-06-2006 03:44 PM |
| Bending Exhaust pipe | ZeeksChopShop | Engine | 7 | 05-30-2004 09:08 PM |
| pipe bending | Kenman | Hotrodders' Lounge | 1 | 05-28-2004 02:15 AM |
