[Hawkfan]

Please see attachment.

I’m starting to wire in the Painless 30107 relay pack into my MSD Multi Retard box. I will be activating the various retards through a lighted, ground break activation switch panel. The retard box is connected to an MSD 6 series multi spark ignition box. This set up is for adding my Nitros system.
My question is that it states in the Painless instructions note # 3 to wire the Green Output wire out of the first relay to the component to be powered such as a fan, fuel pump… Where would this green wire connect to in my case in the attached documents? Would it go to the lighted switch bank I am using to activate the retard actions? Would it go to the retard box its self?
Any assistance would be greatly appreciated.