Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Patch panels and cutting?
View Single Post
  #11 (permalink)  
Old 04-15-2003, 02:50 PM
willys36@aol.com's Avatar
willys36@aol.com willys36@aol.com is offline
Hotrodders.com Moderator
 
Last wiki edit: How to rebuild a Rochester Quadrajet 4MV carbureto...
Last journal entry: How to change auto shift timing on 200R4
Last photo:
Join Date: May 2002
Location: Bakersfield
Posts: 8,393
Wiki Edits: 21

Thanks: 1
Thanked 8 Times in 8 Posts
Post

I butt welded everything on this project. Used MIG w/ .027 solid wire CO2/argon gas. Just did quick spot welds - 1" the 1/2", then 1/4" etc. spacing 'til it was welded solid. No heat distortion whatsoever.



[ April 15, 2003: Message edited by: willys36@aol.com ]</p>
Reply With Quote