|
|
|
05-20-2003, 11:26 AM
|
||||||
|
||||||
Pinion pre-load??
When putting the pinion shaft and bearings back in my Chevy 10 bolt rear end, do I measure the pinion preload before I stick the carrier back in? What torgue should it take to turn it?
Thanks Tom 
|
|
05-20-2003, 04:27 PM
|
||||||
|
||||||
|
you measure pinion bearing load with the pinion only in the carrier, a shop manual will give you the specs, use an inch lb. torque wrench and measure rolling torque. this just locates the bearings and allows no end play.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
