Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Pinto Manual Rack swap.... and Hello!
View Single Post
  #6 (permalink)  
Old 04-11-2003, 03:24 PM
trees trees is offline
Member
 

Last journal entry: JB's 37 Pickup
Last photo:
Join Date: Oct 2002
Location: Smoky Mountains
Age: 76
Posts: 2,358
Wiki Edits: 0

Thanks: 0
Thanked 2 Times in 2 Posts
Post

Jennsen, The 74-78 Mustang II are dimensionally the same as the 74-80 Pinto and Bobcats. However, there are some mounting differences between power and manuak racks but that only is a factor replacing manual with power. If you were loooking at other power racks, there was a ratio change in the later racks and the flared fittings gave way to O ring seal type fittings, again no factor in power to manual swap.

Good hunting.

Trees
Reply With Quote