Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Pistons are .032" in the hole
View Single Post
  #1 (permalink)  
Old 06-17-2012, 08:07 PM
6426yy's Avatar
6426yy 6426yy is offline
Last photo:
Join Date: Nov 2003
Location: Macomb Il.
Age: 37
Posts: 617
Wiki Edits: 0

Thanks: 4
Thanked 6 Times in 6 Posts
Pistons are .032" in the hole

Tearing down one of my 400 small blocks and measuring the installed height of my pistons and every corner is .032 in the hole. Just wondering if anyone else has had them this bad. I used the same piston and rod for each corner. I usually get .022 to .025.
Reply With Quote