Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Pneumatic tool for pitman arm removal
View Single Post
  #1 (permalink)  
Old 11-04-2009, 11:30 AM
killerformula's Avatar
killerformula killerformula is offline
Hotrodders.com Moderator
 
Last wiki edit: Carburetor
Last journal entry: Clean up
Last photo:
Join Date: Oct 2003
Location: Northeast
Age: 33
Posts: 3,485
Wiki Edits: 3

Thanks: 13
Thanked 27 Times in 18 Posts
Pneumatic tool for pitman arm removal

Hey guys-

I was looking at harbor garbage today, and I see there's a cheap set of joint separators as well as an air hammer for low buck. http://www.harborfreight.com/cpi/cta...emnumber=47868

and

http://www.harborfreight.com/cpi/cta...112&zmap=66315

I've only used a standard puller before, but its always been a HUGE pain to get these things off. I hear the secret is to use one of these pneumatic devices. Would this setup have the guts to pop the joint for me?

Thanks-

K

Last edited by killerformula; 11-04-2009 at 11:39 AM.
Reply With Quote