Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Poor boy question
View Single Post
  #3 (permalink)  
Old 06-22-2002, 07:55 PM
Tom Tom is offline
Member
 
Join Date: May 2001
Location: agawam ma
Posts: 323
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post

why not angle mill the heads and use thicker intake gaskets(mr gasket used to make them)angle milling takes more off the exhaust side where the chamber is deepest and reduces the angle of the valves this is a double benifit and doesn't require manifold milling
Reply With Quote