Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Powering my trolley hoist
View Single Post
  #1 (permalink)  
Old 04-10-2008, 07:40 PM
Kruzin Karl Kruzin Karl is offline
Kruzin Karl
 
Last photo:
Join Date: Sep 2004
Location: Sunny South Florida
Age: 44
Posts: 153
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Powering my trolley hoist

Just picked this up off of sleazebay, it's 20 amp 120 volt.

I'm in the middle of doing my plans, or rather, this lazy no good "architect" is supposedely doing them, that's a whole 'nother story, and I need to figure out how I'm going to power this baby up so I can include that on the garage plans.

The garage is sadly only going to be about 22 x 44 feet, the most I can possibly squeeze in between my existing structure, easement on the side, and setback at the ends.

I'm planning on two I-beams longitudinally, with another I-beam running width wise, two trolleys on either side. The winch trolley itself will roll left to right on the center I-beam, and the center I-beam will roll from front to back.

So, with the ability to pretty much slide the winch anywhere in the garage, how do I supply it with a power source that will move with it?

A power reel of some kind in the center? Flexible wiring of some kind?

Hopefully someone has done this or seen it done.

Thanks - Karl
Attached Thumbnails
Click image for larger version

Name:	trolley winch.jpg
Views:	299
Size:	27.1 KB
ID:	29170  
Reply With Quote