Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Powering my trolley hoist
View Single Post
  #3 (permalink)  
Old 04-14-2008, 09:00 PM
zacknolden zacknolden is offline
New Member
 
Join Date: Apr 2008
Location: Herndon, Kentucky 42236
Posts: 5
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by Kruzin Karl
Just picked this up off of sleazebay, it's 20 amp 120 volt.

I'm in the middle of doing my plans, or rather, this lazy no good "architect" is supposedely doing them, that's a whole 'nother story, and I need to figure out how I'm going to power this baby up so I can include that on the garage plans.

I'm planning on two I-beams longitudinally, with another I-beam running width wise, two trolleys on either side. The winch trolley itself will roll left to right on the center I-beam, and the center I-beam will roll from front to back.

So, with the ability to pretty much slide the winch anywhere in the garage, how do I supply it with a power source that will move with it?

A power reel of some kind in the center? Flexible wiring of some kind?

Hopefully someone has done this or seen it done.

Thanks - Karl

The garage is sadly only going to be about 22 x 44 feet
_____________________________________________
Latest***** ******** Latest ***** ******

Last edited by schnitz; 06-19-2008 at 06:11 AM. Reason: Classified ad. Please use the Hotrodders Classifieds for classified ads.
Reply With Quote