Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Priming my 388ci SBC
View Single Post
  #4 (permalink)  
Old 07-01-2007, 09:09 AM
strokey strokey is offline
Registered User
 
Join Date: Jun 2007
Location: NY
Posts: 46
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
That seems to be the exact tool I used.

I primed the system thoroughly with the tool. In fact the smaller diamater part of it at the top ended up breaking off near the end (woops! sorry autozone )

The valves on the two lifters that did not pump up very much were compressed not sure if this would have any affect?

Should I make turning the crank 1/4 revolutions with additional priming my next step?
Reply With Quote