Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (
-   Engine (
-   -   professional products (

82c10 06-10-2005 08:52 PM

professional products
Professional products anyone use their intakes, do the ports match up, would you buy one again

WakBordr7387 06-10-2005 09:24 PM
Its been posted and discussed before, Ive never used them. But I have seen a few of their intakes up close when they were on display and not on an engine. From what I could tell there was alot of casting flash and didn't seem as good as an edelbrock or holley to me.


wshinn 06-10-2005 09:29 PM

I am using their air gap clone with a 1 inch torque plate on a stroked 350 SBC. Have excellent results and very happy with the performance.

347mustang 06-11-2005 08:05 AM

this is a repeat but here goes my freind has a 10 sec chevy nova 2..400 chevy on noitrous..that has the victor look a like intake,..yes they have a loittle rough looking ports inside..but 10 min with a hig speed and it looked fine...for 50-80 or less than a real victor..i was im pressed with it..i also had a performer knock off..on my semmed to work fine and i installed it as it came from the factory...i would buy another one if i was on a budget but probaly a real name brand if i had lots of s10 was all made up of summit brand -profisionall producst and off the wall brands and it was killer..and done for about half the cost of buying name brand parts

MI2600 06-11-2005 10:43 AM

I've heard of sealing problems with their Vortec intakes, but no personal experience. For my own piece of mind, I'd rather pick up a good used brand name than trust to the Chinese clone.

347mustang 06-11-2005 07:28 PM

i mean less

All times are GMT -6. The time now is 06:01 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.