Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Pulley Thead bad looking for Tap. bolt 09440024
View Single Post
  #3 (permalink)  
Old 10-06-2010, 03:28 PM
monette999 monette999 is offline
Registered User
 
Last photo:
Join Date: Feb 2008
Location: ILM NC
Posts: 82
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Hello Eric if I go after the ANSI table I have 20 threads per inch.

1 inch is 25.4mm. If I devide 25.4mm/ 20thread I get the slope 1.27mm per thread. Am I correct.
That 2.25 in is the lenght.
Than should be this the correct thread.

Thanks for your help.

7/16" - 20 UNF 0,438 11,112 9,90 20 1,270
Attached Files
File Type: pdf unf-gewinde.pdf (125.1 KB, 637 views)
Reply With Quote