Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Pump them up?
Thread: Pump them up?
View Single Post
  #96 (permalink)  
Old 02-04-2013, 05:21 AM
malc's Avatar
malc malc is offline
Living At The Speed Of Life
 
Last photo:
Join Date: Jun 2003
Location: Espaņa Right Coast
Posts: 3,322
Wiki Edits: 0

Thanks: 117
Thanked 158 Times in 130 Posts
Here is a snapshot of my number one cylinder (@ TDC) exhaust roller rocker,
taken today.
My block is a stock roller cam block, the heads are Brodix IK200, head gasket
Clevite, CLE-5746, compressed height 0.026.
The pushrod is stock length and you can see the roller tip is just inboard of the valve stem centerline.
Maybe I was just lucky but stock length seems a good place to start.



Wezz The stock pushrod is way to short I can push the pushrod realy up and down. Like u see in the picture i post earlier in the topic

Have you adjusted it correctly ?
Reply With Quote