Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - quick clutch install question
View Single Post
  #3 (permalink)  
Old 12-23-2011, 09:19 PM
chevy1500z71's Avatar
chevy1500z71 chevy1500z71 is offline
Registered User
 
Last photo:
Join Date: Jan 2009
Location: florida
Posts: 225
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by matts37chev
if the shaft is all beat up, I would think a bushing would be more forgiving
but it will still have to be kind of in spec.

I would go get a bushing and test fit, it
if its to sloppy, you may have to replace the shaft
its beet up, i have a real good feeling that a brass bushing will fit over it with no slop, its just a matter of low actual contact area. maybe bring the piece with me to the machine shop and have it turned down and get a different bearing. when i lived in south florida there was a small bearing place in the industrial park that i could walk in and get just about any size bearing for anything, bearings is all they did. i wonder if Im gonna find a place like that up here in central florida?
Reply With Quote