Hot Rod Forum banner

Radiator support rods

2K views 5 replies 5 participants last post by  1937MoPar 
#1 ·
Anyone know of any companies who make custom lenght radiator support rods out there ?
 
#5 ·
I made mine from 1/2" diameter aluminum rod I bought at Home Depot. I drilled & tapped both ends. Bent the rods in a vise using aluminum sheet stock for protection from the vise jaws and then polished them. They really shine nice. I used some welding rod to mock up the length so I got it right on the 1st try. I'm using stainless button head cap screws on the radiator end with a couple of washers for attachment.
:cool:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top